Operating instructions

36
E
RS-232C command table
How to read the command table
Command: Commandeld(Seepage32.)
Direction: W Whenthe“Parameter”issetintheparametereld(seepage32),thecommandfunctionsasdescribed
under“Control/ResponseContents”.
R Thereturnedvalueindicatedunder“Reply”canbeobtainedbysetting“????”,“
?”or“???+”
(repeatercontrol)intheparametereld(seepage32).
Parameter: Parametereld(Seepage32.)
Reply: Response(Returnedvalue)
*1: WhenSTANDBYMODEisSTANDARD.
*2: WhenSTANDBYMODEisLOWPOWER.
“○”: indicatesacommandwhichcanbeusedinpowerstandbymode.
“–”: indicatesacommandwhichcannotbeusedinpowerstandbymode.
Power control/Input mode selection
Function
Command Direction
Parameter Reply Control/Response contents *1 *2
POWERCONTROL POWR W 0
Switchestostandbymode.
-
1 Returnsfromstandbymode.
R 0 Standbymode
1 Normalmode
2 Inputsignalwaitingmode
INPUTMODESELECTION INPS W 0 Togglechangeforinputmode.
*3
-
1 DVI-D
2 D-SUB[RGB]
3 D-SUB[COMPONENT]
4 D-SUB[VIDEO]
9 HDMI[AV]
10 HDMI[PC]
11 USB
R 1 DVI-D
-
2 D-SUB[RGB]
3 D-SUB[COMPONENT]
4 D-SUB[VIDEO]
9 HDMI[AV]
10 HDMI[PC]
11 USB*4
*3Cannotbeusedininputsignalstandbymode.
*4IfpowerstandbymodeisenteredwhentheinputmodeisUSB,theinputterminalthatwasusedpriortoswitchingtoUSB
willrespond,notUSB.
SCREEN menu
Function
Command Direction
Parameter Reply Control/Response contents *1 *2
SIZE(DVI-D,HDMI[PC],D-SUB[RGB]) WIDE WR 1-3 1-3 1:WIDE,2:NORMAL,3:DotbyDot
- -
SIZE(HDMI[AV],D-SUB[COMPONENT],
D-SUB[VIDEO],USB)
WIDE WR 1,4,5 1,4,5 1:WIDE,4:NORMAL,5:DotbyDot
AUTO ASNC W 1 WhentheinputmodeisD-SUB.
PICTURE menu
Function
Command Direction
Parameter Reply Control/Response contents *1 *2
BRIGHT VLMP WR 0-31 0-31
-
COLOR
ADJUSTMENT
COLORMODE BMOD WR 0 0 STD
2 2 VIVID
3 3 sRGB(WhentheinputmodeisDVI-D,D-SUB[RGB],HDMI[PC])
4 4 HIGHILLUMINANCE
5 5 USB
Controlling the Monitor with a PC (RS-232C)