Instruction manual

Setting the USB ash drive cover
Batteriesandaninsulationsheetarepreinstalledintheremotecontrolatthefactory.Beforeusingtheremotecontrol,besureto
remove the insulation sheet.
Insulation sheet
Pullout
Preparing the Remote Control Unit
1. Insert the USB ash drive into the USB port.
USB port
2. Attach the USB ash drive cover and secure with the provided screw.
Inserttheclaw(1)intothemonitor,andwhilepressinginthedirectionof(2),inserttheclaw(3)intothemonitor.
(2)
(3)
(3)
(1)
Screw
(black)
USB flash drive cover
Caution
• Donottouchanyscrewsotherthantheblackscrew.
Dangerofreorelectricalshockifascrewotherthantheblackscrewisremoved.
TIPS
• IftheUSBashdrivewillbeattached,useaUSBashdrivewithdimensionsnogreaterthan3-1/8inch(80mm)(L)×15/16
inch(25mm)(W)×7/16inch(12mm)(H).
• ToremovetheUSBashdrivecover,reversetheprocedure.Usingexcessiveforcemaybreaktheclaws.Exercisecaution.