Owner's Manual
Table Of Contents
- Introduction
- Quick Start
- Setup
- Connections
- Basic Operation
- Useful Features
- Operating with the Remote Control
- Menu Items
- Using the Menu Screen
- Picture Adjustment (“Picture” Menu)
- Adjusting the Projected Image (“SCR - ADJ” Menu)
- Adjusting the Projector Function (“PRJ - ADJ” Menu)
- Auto Sync (Auto Sync Adjustment)
- Auto Power Off Function
- Auto Restart Function
- STANDBY Mode
- Setting the Confirmation Sound (System Sound)
- Audio Output Type Setting
- Speaker Setting
- Audio Input
- Selecting the Transmission Speed (RS-232C)
- Fan Mode Setting
- System Lock Function
- Checking the Lamp Life Status
- Keylock Function
- Setting up the Projector Network Environment (“Network” menu)
- Troubleshooting with the “Help” Menu
- Appendix
17
Quick Start
1 Adjusting the focus.
2
Adjusting the height.
3 Adjusting the picture size.
4. Adjust the projected image
BP. 27
Correcting trapezoidal distortion using Keystone Correction.
On the projector
On the remote control
Shrinks
upper side.
Shrinks
lower side.
5. Correct trapezoidal distortion
BP. 2 8
Select the “COMPUTER” using INPUT on the projector or COMPUTER on the remote
control.
On the
projector
On the remote
control
INPUT list
INPUT
COMPUTER
DVI-D Computer
D
DVI-D Video
D
On-screen display (RGB)
RGB
1024 × 768
COMPUTER
When you press INPUT on the projector, the INPUT list appears.
Press / to switch the Input mode.
•
6. Select the Input mode
BP. 2 9
7. Turn the computer on
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
Standby mode.
On-screen display
On the
projector
On the remote
control
8. Turn the power off
BP. 2 6