Specifications

Question: Why can’t I select the display with Fn+F5 key combination?
•
Confirm the refresh rate of the external monitor is set to 60Hz. Refresh rate larger
than 60Hz disables
Fn+F5
key combination.
•
Select the display in Display Properties dialog box of Control Panel.
Question: Why can’t I change the display mode?
•
Set Colors to 256 colors, and Screen Area to 640 by 480 pixels once; then,
change them again.
Trouble with Keyboard/Glide Pad
Question: Why doesn't the keyboard or the glide pad function?
•
Perform a software reset by pressing
Ctrl+Alt+Delete
.
•
If you cannot perform a software reset, press the power switch for more than four
seconds to turn off the system. Five seconds later, turn the computer on.
•
If you cannot power off the system with above procedures, insert a fine rod into
the reset switch on the bottom side of the computer (refer to page 2-3). Wait ten
seconds and turn the computer back on.
Question: Why doesn't the glide pad function correctly?
•
Confirm the item Pointing Device in the Advanced menu of the Setup Utility is set
to Enabled.
•
Confirm the surface of the glide pad is completely dry and free from dirt and
grease.
•
Remove the PS/2 mouse if connected.
Trouble with Floppy Disks
Question: Why can't I use a floppy disk?
•
Confirm the floppy disk is inserted correctly.
•
Confirm the drive or the file name is correct.
•
The floppy disk may not be formatted or could be corrupted.
•
If you cannot write to a floppy disk, the disk may be write-protected. Eject the
disk and ensure that the write-protect tab covers the detection hole.
•
If you cannot write to a floppy disk, the disk may be full. Use another disk.