Specifications

5-4
5
Disabling Power Management
To use communication software, you may have to disable
System standby/hibernate
.
See
Disabling Power Management
in Chapter 3.
Setting Communication Information
1. In the
Modems Properties
dialog box, select
Dialing Properties
.
2. In
Dialing Properties
dialog box, set country/region, line type, outside line dial
etc., following the instructions on the screen.
Setting Communications Software
1. Within the communications software you are using, set the COM port of the
built-in modem to COM3 if you have not changed the default settings.
2. Set parameters such as modem speed (baud rate) and line type (pulse dialing or
tone dialing).
• See also the manual or online help of the software you are using
.
• Do not enter
System standby/hibernate
while using communication
software.
• The communication speed may vary depending on the traffic, local
telecommunications infrastructure, and ISP (Internet Service Provider)
infrastructure.
• Before commencing with fax communication, it is recommended that
you exit other application programs.