User`s manual

1-3
3. Never install ZM-62E in the same compartment
as high-voltage equipment. The unit should be at
least 200 mm away from high-voltage lines or
power cables.
Usage
1. An emergency stop circuit must be composed of
an external relay circuit with a start signal for
ZM-62E built in. Do not create switches on
ZM-62E to be used in case of emergency.
2. In case of using a waterproof sheet (GD-WP80E),
mount it in the unit by using 6 pieces of mounting
screws (normally 4 pieces of them).
3. ZM-62E has a glass screen. Never drop or
subject the unit to strong impacts.
POWER
RUN
POWER
RUN
Emergency
Stop
Switch to be used
in emergency
P
OW
E
R
R
U
N
4. Tighten mounting screws with the following
torques.
Note :Never fasten these screws too tightly,
otherwise the cover of ZM-62E may be deformed.
Screw Size
M3
Torque (N · m)
0.3-0.5 (3-5kgf · cm)
Position of Screw
Mounting Screw
Lock !
POWER
RUN
POWER
RUN
alcohol
BENZINE
BENZINE
POWER
RUN
POWER
RUN
a tool with a
sharp point
like a screwdriver
1 Notes on Usage
5. In a dry environment, ZM-62E may generate a large
amount of static electricity.
Therefore, before touching the unit, touch a
grounded metallic section to discharge the static
electricity.
6. Securely fasten and lock every connector for each
cable. Double-check this before turning the power
on.
7. Application of thinner may discolor ZM-62E.
Use alcohol or benzine available commercially for
cleaning.
8. Never remove any printed circuit board from
ZM-62E. (This will harm the unit.)
9. Never operate the display by using a tool with a
sharp point like a screwdriver.
Touch the display by fingers.
Notes on Design
1. Use all the display area evenly and avoid using
fixed patterns which may cause afterimages so that
the life span of the display can be expanded.