User`s manual

3-15
ZM-30 (ZM-61E) ZM-
**
(ZM-62E)
Model
Item
Editing No./name
in the memory
card mode
• Multi-overlap is always
used.
• Editing is impossible
unless [Memory] bit 12
of the numeric keypad
entry mode/character
entry mode for No./
editing is set ON.
• An overlap is deleted
when the [ENT] key is
pressed and the card
No. or the card name
/file name/record name
is entered
In the state after conversion, converted data cannot be
used as it is.
Take the following into consideration.
1) In the state the normal overlap for [Type: Multi] is reg-
istered in the screen, the overlap is transferred to the
same area of the screen No. of [multi-overlap edit].
2) The entry mode on the overlap is always changed to
[Type: Memory Card].
3) [Num. Display] parts or [Char. Display] parts of
[Display Function: Entry display] are always set in the
same DIV as the entry mode on the overlap.
4) If [Data Block Area] is set on the overlap, it is deleted
since it is unnecessary.
5) Name display parts are automatically converted in
[Bytes: 3]. Therefore, setting should be changed if
necessary.
The memory card mode operates normally by the setting
indicated above.
* [Command Memory] operation in the [Entry] mode is
not necessary.
Record No. 1
Record Name ABC
File Select File Name Edit
Record Select Rec Name Edit
File No. 1
File Name ABC
BCDA
FGHE
Record Name ABC
For the screen on ZM-30 (ZM-61E), where nothing is
registered other than the normal overlap.
Screen No. 20: ZM-30 (ZM-61E)
BCDA
FGHE
Record Name ABC
At ZM-
**
(ZM-62E), the normal overlap is
automatically registered in the same number
as multi-overlap edit.
Multi-overlap edit No. 20: ZM-
**
(ZM-62E)
Entry mode
[Type: Data Display (or Block)]
[Type: Memory Card]
2)
1)
3)
5) For checking [Bytes]
Screen No. 19: ZM-
**
(ZM-62E)
Display function: Entry Target
Display Function: Entry Display
CR
CR
3 ZM-61E -> ZM-62E Conversion