User`s manual

3-12
Model
Item
Character Entry
mode
Entry mode
• [Type: Data Display]
• [Command Memory: (same as [Memory] in ZM-30 (ZM-61E)]
• [Info. Output Memory: (converted to Write Area n+2)]
• [Target Memory: Direct]
• [Input Item Select: Internal]
• [Detail] tab window
[Use Graphic]
• For character displays on a screen, [Display Function: Entry Target] is set.
• The DIV No is converted as follows.
• For [Result Display: checked], the numerical display [Display Function:
No] is set in the same DIV No. as that of a statistics graph. [Memory] of
each numerical display is the same as [Memory] of the graph.
• For [% Display: checked], the numerical display [Display Function: Display
Statistics Graph %] is set in the same DIV No. as that of a statistics graph.
Statistics graph
mode
ZM-
**
(ZM-62E)
ZM-30
(ZM-61E)
ZM-30 (ZM-61E)
General-purpose
serial communi-
cation
General-purpose serial
communication protocol,
special to ZM-30
(ZM-61E), is used.
Impossible
Since the general-purpose communication protocol,
special to ZM-
**
(ZM-62E) series, is used, the protocol
is not compatible.
Overlap
[Type: Multi]
Memory “n”:
Indicates the screen No.
where the displayed
overlap is registered.
When the overlap is
cleared, the screen No.
entered last remains in
memory “n.”
Memory “n”:
The number in the [multi-overlap] in which the displayed
overlap is registered.
When the overlap is cleared “-1” (= HFFFF) is set in
memory “n.”
Model
Item
Baud rate
1200 and 2400 bps are
available.
Communication
parameter
Impossible
Both baud rates are automatically converted to 4800 bps.
Display characters Characters to be display-
ed are not influenced by
“Enlarge X/Y” setting.
When an even value is set for “Enlarge X/Y,” such
characters are automatically displayed in 32-dot font.
Accordingly, displayed image will somewhat differs from
the characters displayed at ZM-30 (ZM-61E).
Character-string of
switch/memory
Character-strings are
created in graphics.
Character-strings are converted as graphics.
They are not converted as character-strings in the
[Switch] (or [Lamp]) dialog.
ZM-
**
(ZM-62E)
Incompatible Functions after Conversion
There are functions for which compatibility with ZM-30 (ZM-61E) cannot be maintained after converting to
ZM-
**
(ZM-62E).
The following describes these functions
3 ZM-61E -> ZM-62E Conversion