User`s manual

3-11
ZM-30
(ZM-61E)
Model
Item
[Type: Block]
• [Type: Block]
• [Target Memory: Output Memory]
• [Input Item Select: Internal]
• [ZM-30 (ZM-61E) Compatible] cannot be specified (but checked).
• The settings of tenkey blocks are set in DIV4 as settings for [Data
Block Area] mode.
[Data Block Area] mode
· [Division No: 4]
· [Command: Internal]
· [Initial Block/Min. Block: (Set the number of [Start].)]
· [Max. Block: (Set the number of [End].)]
· [Item Select: (unchecked)] (Set if necessary.)
· [ZM-30 (ZM-61E) Compatible: (checked)]
[Type:
Block Direct]
• [Type: Block]
• [Target Memory: Direct]
• [Input Item Select: Internal]
• [ZM-30 (ZM-61E) Compatible] cannot be specified (but checked).
• The settings of tenkey blocks are set in DIV4 as settings for [Data
Block Area] mode.
[Data Block Area] mode
· [Division No: 4]
· [Command: Internal (same as ZM-30 (ZM-61E)]
· [Item Select: (checked)]
· [ZM-30 (ZM-61E) Compatible: (checked)]
[Type:
Indirect]
• [Type: Data Display]
• [Target Memory: Output Memory]
• [Input Item Select: External]
• [ZM-30 (ZM-61E) Compatible: (checked)]
When there is no overlap, "4" is set. When there is an overlap, the
DIV No. for the overlap of ZM-30 (ZM-61E) is set.
• For numerical displays on a screen, [Display Function: Entry
Target] is set. The number of [Order] is converted automatically as
shown below.
DIV No.
0
1
2
3
Data No.
0 to 31
0 to 31
0 to 31
0 to 31
Order
0 to 31
32 to 63
64 to 95
96 to 127
ZM-30 (ZM-61E)
ZM-
**
(ZM-62E)
Tenkey mode
[Type: Multi]
[Type: Direct]
• [Type: Direct]
• For numerical displays on a screen, [Display Function: No] is set.
* When [Command: External] is set, the address of [Block No. Read Mem.]
is the same as of [Command Memory] in [Entry] mode.
* Specify the same number as [Command Memory] n+1 and choose [2]
words.
• [Type], [Target Memory], [Input Item Select] and [ZM-30 (ZM-61E)
Compatible] are set same as that in case of [Type: Block Direct].
• The settings of tenkey blocks are the same as that of [Data Block
Area] mode in case of [Type: Block Direct].
* When [Command: External] is set, the address of [Block No. Read Mem.]
is the same as of [Command Memory] in [Entry] mode. When the overlap
containing the keypad is stored in another screen (= multi-overlap is
used), [Block No. Read Mem.] is temporarily set in [$u4000]. Be sure to
change it from [$u4000] to the address of [Command Memory].
ZM-
**
(ZM-62E)
3 ZM-61E -> ZM-62E Conversion