User`s manual

3-7
Cautions on conversion
Conversion contents are largely classified into three categories when converting the ZM-61E screen data into
the data for ZM-62E.
ZM-61E compatible functions implemented by ZM-71SE Ver. 1.3.0.0
Data converted as ZM-61E compatible data
Functions that cannot be converted as ZM-61E compatible data (as of ZM-71SE Ver. 1.3.0.0)
Described below are cautionary items to be taken into consideration for each conversion content.
ZM-61E Compatible Functions Implemented by Ver. 1.3.0.0
With the introduction of ZM-71SE Ver. 1.3.0.0, several ZM-61E compatible functions are added. Conversion of
the items below, which could not be converted using the previous editor version, are now made possible.
ZM-61E
Continuous buzzer
sound
The buzzer keeps sound-
ing while read area n, bit
10 is ON.
Possible
By checking [Use continuous buzzer sound] in the
[Environment Setting] tab window of [Unit Setting]
Model
Item
Overlap bit
command
Overlap is displayed
while read area “n+1”, bit
12 is ON.
(The overlap is kept dis-
played even if the display
is changed.)
Possible
By checking [Display an overlap be level of ON bit] in the
[Environment Setting] tab window of [Unit Setting]
With check mark : Same operation as ZM-61E.
Without check mark : Bit 12 setting is recognized at the
signal edge.
(Even if the bit is set ON, the overlap is cleared when the
display is changed.)
ZM-71SE Ver. 1.3.0.0 or later
3 ZM-61E -> ZM-62E Conversion
5. The screen edit window is displayed.
ZM-61E screen converted for ZM-62E is displayed.