User`s manual

2-9
Message Display in Data Transferring
If an error occurs during transferring data, the message display
window shown on the right is displayed. The kinds and the contents
of the messages are as shown below.
Work normally finished.
ZM-1REC not connecting
ZM-1REC Communication Error
Memory-Card not setting
Memory-Card Capacity over
Write Protect : ON
Writing Error occurred.
Selected data does not exist.
ZM type is different.
Selected data can not be read.
Reading Error occurred.
Data discrepant
Screen data on ZM will be broken.
Undefined Error occurred.
The specified operation has been concluded normally.
ZM-1REC is not connecting when selecting a modular jack.
A communication error occurred between ZM-62E and
ZM-1REC when selecting a modular jack.
A memory card is not inserted.
Cannot write the data into a memory card because
the data size in ZM-62E is larger than the capacity of
a memory card.
Cannot write data into a memory card because
the write protect switch in a memory card is ON.
The error occurred while writing data into a memory
card.
The data in the reading target does not exist.
The specified type of the data in ZM-62E is different from
the type of the memory card data.
The data in a memory card cannot be read.
The error occurred during writing data into a flash
ROM of ZM-62E.
There is some discrepancy in data, when comparing data
between a memory card and ZM-62E.
This message appears to inform the user that the data in
ZM-62E will be broken by transferring the font data (the
size which is larger than the present data) from a
memory card to ZM-62E. (The [OK] switch continues the
transferring. The [Cancel] switch stops transferring.)
The error occurred due to some cause other than
the above mentioned.
Message Contents
2 Operation of Main Menu
O K
Work normally finished