User`s manual

1-30
16
Pin No.
1
2
3
4
5
6
7
8
9
Signal
CTS
RXD
TXD
RTS
SG
+5V
Red : 0V
Orange : RXD
Yellow : TXD
Brown : +5V
12345678
* Jump pins, 1(CTS) and 4(RTS).
D-sub 9pin ( )
Signal
RTS
TXD
RXD
CTS
SG
+5V
Barcode Reader
*
Red : 0V
Orange : RXD
Yellow : TXD
Brown : +5V
12345678
Barcode Reader Interface
It is possible to receive the signal from a barcode reader by connecting a barcode reader to ZM-62E via the
modular jack (MJ1/MJ2) of ZM-62E.
To connect a barcode reader to ZM-62E via MJ1/MJ2, use the cable which is the cable for barcode reader
(ZM-80BC: order product).
Length : 3m
Notes on Connection
• In case of using the barcode reader which uses the CTS and RTS control, the barcode reader may
not work normally without jumping RTS and CTS.
• The output power supply (+5V) is max. 150mA. (Refer to page 1-26.)
When the barcode reader connected to ZM-61E is used, connect it to ZM-80BC by the following cable.
1 Barcode Reader Interface