User`s manual

1-28
14
Pin No.
1
2
3
4
5
6
7
8
Signal
+SD/RD
-SD/RD
+5V
+5V
0V
0V
RD
SD
MJ1/2
12345678
Output power supply
Max. 150mA
Modular Jack 1 & 2 (MJ1/2)
The right diagram is the pin arrangement and the
signal name of modular jack 1 & 2.
Modular Jack 1 & 2
Setting of Modular Jack 1 & 2 (MJ1/MJ2)
Specify the use of MJ1/MJ2 by the screen edit software (ZM-71SE).
Select [Modular] of [System Setting], and then the [Modular Jack] dialog is displayed. The setting items of
[Modular Jack 1] and [Modular Jack 2] in this dialog are as follows.
Modular Jack 1 Modular Jack 2
[Editor port] [Not used]
[Memory Card] [Memory Card]
[Barcode] [Barcode]
[ZM-I/O] [ZM-I/O]
[Multi-Link] * [Multi-Link] *
[ Temp./ PLC2Way ][ Temp./ PLC2Way ]
[ZM-Link] [ZM-Link]
[Modbus Slave] [Modbus Slave]
[Printer(Serial Port)] [Printer(Serial Port)]
It is impossible to select both [Multi-Link] and [Temp./ PLC2Way] in each setting of modular jack.
* It is possible to select this item when [Multi-Link 2] is selected for [Connection] and [Local Port] is set to [1] in
the [Comm. Parameter] dialog.
Editor Transferring
Use modular jack 1 (MJ1) in case of editor transferring.
When [Editor port] is selected for [Modular Jack 1] in the [Modular Jack] dialog, it is also possible to
transfer the data while running, because the auto change of the local mode and the run mode is valid.
When [Editor port] is selected, on-line editing and the simulation mode are also available.
When the item other than [Editor port] is selected for [Modular Jack 1] in the dialog, be sure to transfer the
data by the software in the local mode. On-line editing and the simulation mode are not available.
When the data is transferred by software, use the cable for data transferring which is the optional equip-
ment (ZM-80C: 3m) to connect ZM-62E to a personal computer.
1 Modular Jack 1 & 2