User`s manual

1-9
6
Mounting Panel
Cut-out
Panel Cut-out
192
277
+1
- 0
+1 - 0
POWER
RUN
277
+
1
-
0
192
+1 - 0
Mounting panel
Mounting hole
Mounting hole
Fixtures
ZM-62E
25
26
10
(Unit : mm)
Dimensions of Fixtures
Display
Display
Follow the procedure shown below when you fix a ZM-62E to a mounting board.
1. Cut out the mounting panel (Max. thick: 5 mm) to match the dimensions shown below.
Mounting Procedure
2. Insert 4 pieces of the fixtures attached to ZM-62E into the mounting holes on ZM-62E. Tighten them with
the locking screws.
Screws : 4 pcs
Screw Size : M3
Torque : 0.3~0.5 N·m (3~5 kgf·cm)
* Never use 6 pieces of the fixtures to mount ZM-62E.
Mounting Angle
The unit (ZM-62E) shall be installed within the angle of
0 to 135 degrees as shown below.
1 Mounting Procedure