Instruction manual

RazorGage End-User Manual
Technical Services, Inc Page 12
1
2
3
4
5
The Autolist feature uses cutlists that have been run through the Parts List Processor
(See Parts List Processor Manual). The list is arranged first by material, then width,
thickness, and lastly by length from longest to shortest. This is the default sorting
arrangement and can be changed to fit your needs.
Press Select the cutlist you wish to process.
If quantities need to be changed, select the appropriate row, and press or
to raise or lower the quantity.
Select a row that matches your stock width, material, and thickness. When the
row is selected, the RazorGage will move to that position.
Press and enter the length of clear board you have. This can also be
done using the optional scanner. The Autolist software will generate a list of parts
for the maximum use of materials.
An optimized list of parts will appear. The RazorGage will move to the length of
the first part in the list. When the optimized list is cut, the Autolist screen will
return to where you left off.
Press and the quantity of that part will decrement. When the quantity
reaches zero, the part will be crossed out.
Repeat steps 3-6 for additional stock lengths.
6