Instruction manual
Table Of Contents
- Notes on using your camera
- Table of Contents
- Preparing the camera
- Before your operation
- Shooting images
- Using the shooting function
- Selecting the focus method
- Zooming in in one step
- Using the flash
- Adjusting the brightness of the image (Exposure, Flash compensation, Metering)
- Shooting with fixed brightness (AE Lock)
- Using brightness compensation for the entire image (Exposure compensation)
- Adjusting the amount of flash light (Flash compensation)
- Selecting the flash control mode to set the amount of flash light (Flash control)
- Selecting the method for measuring the brightness of a subject (Metering mode)
- Compensating for the brightness and contrast automatically (D-Range)
- Image processing
- Setting ISO
- Adjusting the color tones (White balance)
- Selecting the drive mode
- Capturing smiling faces (Smile Shutter)
- Using the viewing function
- Changing your setup
- Viewing images on a computer
- Printing images
- Others
- Index
Others
167
• When you print images at a shop, images can be printed with the date if you
ask them to do so.
For details, refer to the operating instructions supplied with the printer or
consult with the manufacturer of the printer.
A connection cannot be established.
• The camera cannot be connected directly to a printer that is not compliant
with the PictBridge standard. Consult the printer manufacturer as to
whether the printer is compliant with PictBridge or not.
• Set [USB connection] to [PTP] (page 154).
• Disconnect and connect the USB cable again. If an error message is
indicated on the printer, refer to the operating instructions supplied with the
printer.
Cannot print images.
• Check that the camera and the printer are properly connected using the USB
cable.
• RAW images cannot be printed.
• Images shot using cameras other than this camera or images modified with
a computer may not be printed.
Cannot print the image at the size selected.
• Disconnect the USB cable and reconnect it whenever you change the paper
size after the printer has been connected to the camera.
Cannot operate the camera after canceling printing.
• Wait for a while as the printer is carrying out the cancellation. It may take
some time depending on the printer.
The lens gets fogged.
• Moisture condensation has occurred. Turn off the camera and leave it for
about an hour before using it (page 172).
PictBridge compliant printer
Others