User manual

Operation
Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Page 28 of 57
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
To replace the battery:
Only for MC95xx
ex
-NI, type B7-A292-…./…….. UL Class I, II, III Division 2
(1) If the MC 95xx
ex
-NI is in suspend mode, press the red Power button to wake the
device.
(2) Press the red Power button to suspend the MC 95xx
ex
-NI.
(3) Wait for red Decode LED to turn on and then turn off.
(4) Unhook the handstrap.
(5) Press the two battery release latches to release the battery. The battery ejects
slightly.
Figure 4-11: Removing the battery (UL Class I, II, III Division 2)
(6) Lift the battery from the MC 95xx
ex
-NI.
(7) Insert the replacement battery, top first, into the battery compartment in the back of
the MC 95xx
ex
-NI.
(8) Press the battery down until the battery release latches snap into place.
The MC 95xx
ex
-NI powers up after inserting the battery.
Only for MC95xx
ex
-NI, type B7-A293-…./…….. ATEX Zone 2 and Zone 22
(1) If the MC 95xx
ex
-NI is in suspend mode, press the red Power button to wake the
device.
(2) Press the red Power button to suspend the MC 95xx
ex
-NI.
(3) Wait for red Decode LED to turn on and then turn off.
(4) Unhook the handstrap.
(5) Put the special tool inside of the two
holes to release the battery latches to
release the battery. The battery ejects
slightly.
Special tool for the battery latch release
Figure 4-12: Removing the Battery (ATEX Zone 2 and Zone 22)
Hole for the battery latch