User manual

Operation
Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Page 22 of 57
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
Caution!
Follow proper ESD precautions to avoid damaging the micro SD card. Proper
precautions include, but are not limited to, working on an ESD mat and ensuring that the
operator is property grounded.
Figure 4-3: Insert micro SD Card Holder in Holder
(10) Close the card holder door and slide to the right to look into place.
(11) Align the SD card cover over the access hole and press down until it snaps into
place.
4.4.2 Removing the micro SD card
Caution!
Suspend the MC 95xx
ex
-NI prior to removing the battery. Failure to properly remove the
battery may cause the MC 95xx
ex
-NI to cold boot and potential loss of data.
This is how you remove a micro SD card:
(1) If the MC 95xx
ex
-NI is in standby mode, press the red Power button to activate the
device
(2) Press the red Power button to suspend the MC 95xx
ex
-NI.
(3) Wait for red decode LED to turn on and then turn off.
(4) Unhook the handstrap.
(5) Remove the battery.
(6) Remove the SD card cover using the end of the stylus.
(7) Slide the SD card holder door to the left to unlook.
(8) Lift the micro SD card holder door.
(9) Remove micro SD card from holder.
(10) Close the micro SD card holder door.
(11) Slide the micro SD card holder door to the right to look into place.
(12) Align the SD card cover over the access hole and press down until it snaps into
place.
(13) Replace the battery.