Instruction manual
3・25
Chapter 3 Basic Operation (Function Summary)
■ Setup
■ Display
Function
Select the PC models that are objects of the edit/monitor.
Select the capacity of the program memory.
Setup the communication methods with the PC.
Initialize the internal memory of this personal computer using this software.
Setup the input type (input mode, continuous address input, etc...).
Setup the display position of coil, TMR/CNT instruction, application instruction.
Assign keys to input ladder mnemonic.
Select "yes/ no" for checking "input of same symbol" when registering symbol.
Command
Model Setup
Memory Capacity Setup
Communication Setup
Memory Clear
Setup Input Type
Setup Display
Key Layout
Check Input of Same
Symbol
Function
Select the display of the address/symbol inside the ladder program.
Change between ladder and mnemonic window.
Assign the monitoring type of the ladder program (notation display
yes/no),and the register display type (octal/decimal/hexadecimal)
Change between the file 8 and file 9 of the program area.
[Data List] window is opened. Here, address (contact number,
register number etc...), symbol, comment and cross reference that
are being used in the program are displayed.
Execute the connection of the disconnected circuit, the display
position adjustment of the output instruction, the adjustment of
MCS/JCS condition display, and optimize the ladder circuit.
Displays data in binary notation.
Displays data in octal notation.
Displays data in decimal notation.
Display data in decimal notation with a sign of plus or minus.
Displays data in hexadecimal notation.
Displays data in ASCII character.
Displays data in 1 byte (8 bit data) unit.
Displays data in 1 word (16 bit data) unit.
Displays data in 2 word (32 bit data) unit.
Displays data with comment.
Displays data in a summary list.
Select“yes/no”display of the main toolbar.
Select“yes/no”display of the sub toolbar.
Select“yes/no”display of the status bar.
Select“yes/no”display of the tree bar.
Select“yes/no”display of the toolbar for editing the ladder.
Select“yes/no”display of the toolbar for editing the mnemonic.
Select“yes/no”display of the toolbar for editing the data.
Select“yes/no”display of the message bar.
Command
Display Type
Change Display
Changes Type of Monitor
Change Segment Display
Data List
Arrange Ladder Diagram
Display in Binary Notation
Display in Octal Notation
Display in Decimal Notation
Display in Decimal Notation
(with +/-)
Displays in Hex Notation
Display in ASCII
Display in Byte
Display in Word
Display in Double Word
Detail Display
Display in List
Main Toolbar
Sub Toolbar
Status Bar
Tree Bar
Toolbar for Edit Data (L)
Toolbar for Edit Data (
I
)
Toolbar for Edit Data (E)
Message Bar