Instruction manual

3・24
Chapter 3 Basic Operation (Function Summary)
■ Instruction
■ Monitor
Function
Used for inputting A contact when editing ladder.
Used for inputting B contact when editing ladder.
Used for inputting horizontal line when editing ladder.
Used for inputting vertical line when editing ladder.
Used for inputting STR, STR NOT, AND STR, OR STR when editing
mnemonic.
Used for inputting STR NOT, AND NOT, OR NOT when editing mnemonic.
Used for inputting AND, AND NOT, AND STR when editing mnemonic.
Used for inputting OR, OR NOT, OR STR when editing mnemonic.
Used for inputting OUT instruction（coil）
Used for inputting TMR instruction.
Used also for inputting TMR contact when editing mnemonic.
Used for inputting CNT instruction.
Used also for inputting CNT contact when editing mnemonic.
Used for inputting application instruction.
Used for inputting F-43 instruction（revert bit）.
Used for inputting F-44 instruction（differential ON）.
Used for inputting F-45 instruction（differential OFF）.
Used for inputting F-20 instruction（MD）.
Command
A Contact
B Contact
Horizontal Line
Vertical Line
STR
NOT
AND
OR
OUT
TMR
CNT
FUN
F43
F44
F45
F-20（MD）
Function
Start the monitoring.
Stop the monitoring.
ON/OFF the relay of the PC with force.
Change the ladder circuit of the PC in the monitoring.
Insert the ladder circuit of the PC in the monitoring.
Delete the ladder circuit of the PC in the monitoring.
Command
Start Monitoring
Stop Monitoring
I/O Forced Processing
Edit Circuit [Change]
Edit Circuit [Insert]
Edit Circuit [Delete]