Instruction manual

3・19

Chapter 3 Basic Operation (Selection of Commands)

3-5 Selection of Commands

A command is an instruction for JW-100SP to take the responsible tasks.

To select a command, one of the following operations is taken in measure.

①Click the button of the toolbar (Main Toolbar, Sub Toolbar)

②Select the command from the menu.

③Select the command from the shortcut menu.

④Use the shortcut key.

■ Click the Button of the Toolbar

(Example:In case of [Find])

■ Select the Command from the Menu

Commands are grouped and stored in the menu.

(1)

When selecting the command by mouse

If you want to select a command by mouse, click the menu name of the menu bar, and then click the

command name.

The command that has

▼

mark on the right side of the command name contains the sub menu, so

that after moving the mouse pointer to the command name, you can click the command name of the

sub menu.

To close the menu without selecting the command, click simply outside of the menu.

Click here

Sub menu