Instruction manual

3・8
Chapter 3 Basic Operation (Screen Configuration)
◎◎
◎◎
◎A Contact Same as [Instruction]-[A contact]
Used when inputting A contact.
◎◎
◎◎
◎B Contact Same as [Instruction]-[B contact]
Used when inputting B contact.
◎◎
◎◎
◎Vertical Line Same as [Instruction]-[Vertical Line]
Used when inputting vertical line.
◎◎
◎◎
◎Horizontal Line Same as [Instruction]-[Horizontal Line]
Used when inputting horizontal line.
◎◎
◎◎
◎OUT Instruction Same as [Instruction]-[OUT]
Used when inputting OUT instruction (coil).
◎◎
◎◎
◎TMR Instruction Same as [Instruction]-[TMR]
Used when inputting TMR instruction.
◎◎
◎◎
◎CNT Instruction Same as [Instruction]-[CNT]
Used when inputting CNT instruction.
◎◎
◎◎
◎Application Instruction Same as [Instruction]-[FUN]
Used when inputting application instruction.
◎◎
◎◎
◎F-45 Instruction Same as [Instruction]-[F45]
Used when inputting F-45 instruction (differential OFF).
◎◎
◎◎
◎F-44 Instruction Same as [Instruction]-[F44]
Used when inputting F-44 instruction (differential ON).
◎◎
◎◎
◎F-43 Instruction Same as [Instruction]-[F43]
Used when inputting F-43 instruction (revert bit).
◎◎
◎◎
◎Widen/Narrow Frame
Used when you need to extend the frame downward in result of the added OR circuit by,
for example, CNT instruction or multiple inputs of application instruction (F-60 etc..).
◎◎
◎◎
◎Eraser
Used when erasing the circuit (cell unit).
◎◎
◎◎
◎Convert
Convert the ladder circuit to mnemonic.
◎◎
◎◎
◎Change Cursor Type
In case of direct input mode, it changes the instruction cursor to the mouse cursor with
arrow.
■ Toolbar for Editing Ladder
Use when creating ladder program.