Instruction manual

3・5
Chapter 3 Basic Operation (Screen Configration)
◎◎
◎◎
◎New Same as [File]-[New]
Create a new file (program, system memory, data memory, symbol/comment,
or parameter).
◎◎
◎◎
◎Open Same as [File]-[Open]
Open the existing file (program, system memory, data memory, symbol/comment,
parameter).
◎◎
◎◎
◎Save Same as [File]-[Save]
Save the set of the files in operation (program, system memory, data memory, symbol/
comment, or parameter) under the current file names.
◎◎
◎◎
◎Cut Same as [Edit]-[Cut]
Cut the selected area and saves it for the moment.
◎◎
◎◎
◎Copy Same as [Edit]-[Copy]
Save the selected area and saves it for the moment.
◎◎
◎◎
◎Paste Same as [Edit]-[Paste]
Paste the data that was cut or copied onto the position of the cursor.
◎◎
◎◎
◎Image Copy Same as [Edit]-[Image Copy]
Temporarily keep in the clipboard the selected area you are editing in the ladder program
window as an image data.
◎◎
◎◎
◎Undo Same as [Edit]-[Undo]
It brings back the previous state of the operation.
◎◎
◎◎
◎Change Display Same as [Display]-[Change Display]
Change the window of the ladder and mnemonic.
◎◎
◎◎
◎Change Segment File Same as [Display]-[Changes Segment Display]
Change between file 8 and file 9 of the program area.
◎◎
◎◎
◎Program Check Same as [Edit]-[Program Check]
Execute the program check.
◎◎
◎◎
◎Arrange Ladder Diagram Same as [Display]-[Arrange Ladder Diagram]
Execute the connection of the disconnected circuit, adjustment of the display
position,adjustment of the MCS/JCS condition display, and optimize the ladder circuit.
◎◎
◎◎
◎Print Same as [File]-[Print]
Print contents of the active window (ladder program, mnemonic program, system memory,
data memory, symbol /comment, parameter).
■ Main Toolbar
PC model name Program memory capacity Project name