Instruction manual

Chapter 9 Print (Page Setup)
9・8
[5] Setup Page of Symbol
If you click [Page Setup] by the [File] menu (page 9-1) of symbol, the [Symbol Print Setup] dialog
box will be displayed.
③
①
②
※ By clicking [Reference] (number ①) of each item, you can assign the file name by
[Select File] dialog box at the title/header/footer. (Same as the pages 9-3 to 4)
Also, the file for title/header/footer is created by clicking [Boot HF Editor] (number
2 above) (⇒Refer to "9-2 HF Editor")
If you click [OK] (number 3 above) after setting up each item, the setup content will be registered.
Setup items
Title
Header
Footer
Start address to print
End address to print
Unit to print
Unused Address
Comment
Margins
Boot HF Editor
If you want to print the title, select "Attach," and if you don't want to print the title,
select "None." Assign the file name if you select "Attach." ※
For each page, select "Attach/None" (as explained above) in printing the header.
Assign the file name if you select "Attach." ※
For each page, select "Attach/None" (as explained above) in printing the footer.
Assign the file name if you select "Attach." ※
You cannot set up this item. (The unit is always byte.)
You cannot set up this item.
(Only the address that symbol/comment is registered is printed.)
Select the printing of the symbol/comment from "Symbol/Comment, Symbol,
Comment."
Assign data memory address that starts the printing.
Assign data memory address that quits the printing.
Setup spaces of
top/bottom/left/right sides.
Start-up "HF Editor" that creates title, header and footer.
Content