Instruction manual

Chapter 9 Print (Page Setup)
9・7
[4] Setup Page of Data
If you click [Page Setup] by the [File] menu (page 9-1) of data, the [Data Print setup] dialog box will
be displayed.
③
①
②
※ By clicking [Reference] (number ①) of each item, you can assign the file name by
[Select File] dialog box at the title/header/footer. (Same as the pages 9-3 to 4)
Also, the file for title/header/footer is created by clicking [Boot HF Editor] (number
2 above) (⇒Refer to "9-2 HF Editor")
If you click [OK] (number 3 above) after setting up each item, the setup content will be registered.
Setup items
Title
Header
Footer
Start address to print
End address to print
Unit to print
Print format
Comment
Margins
Boot HF Editor
If you want to print the title, select "Attach," and if you don't want to print the title,
select "None." Assign the file name if you select "Attach." ※
For each page, select "Attach/None" (as explained above) in printing the header.
Assign the file name if you select "Attach." ※
For each page, select "Attach/None" (as explained above) in printing the footer.
Assign the file name if you select "Attach." ※
Select the unit（byte/word/double word ) for printing data of memory data.
・It is valid only when selecting except "None" at comment（described below).
Select the type(binary notation/octal notation/decimal notation/decimal notation
(with +-)/hexadecimal notation/ASCII) for printing data of data memory.
Select "symbol/comment print" of data memory from
"None,Symbol,Comment,Symbol/Comment."
Setup spaces of top/bottom/left/right sides.
Start-up "HF Editor" that creates title, header and footer.
Assign data memory address that starts the printing.
Assign data memory address that quits the printing.
Content