Instruction manual

8・16

Chapter 8 Monitor (Sampling Trace)

[1] Sampling Trace order

The order to execute sampling trace will be explained.

. .

. Setup PC model

・ Setup the compatible PC model by the [Setup]-[Select PC Model] of the menu bar.

・ If you start sampling trace in JW-100SP, you cannot change models. (It will be the model in

operation with JW-100SP.)

. .

. Setup communication

Set up communication by selecting [Setup]-[Communication Setup] in the menu bar.

. .

. Create trigger condition

Edit the trigger condition by selecting [Edit]-[Trigger Condition] in the menu bar.

・Create a ladder program to be the trigger condition. You do not have to create a coil (OUT

instruction).

・The ladder program that can be the trigger condition has maximum five contacts. You cannot

input ladder mnemonics in the highlighted area below.

When the ladder mnemonic of A is input, the B cell is highlighted.

Switch to the Sampling

Condition window.

・Click [Switch to the Sampling Condition window] in the tool bar.

You cannot input ladder mnemonics in the cell of the highlighted area.

(Program Example)