Instruction manual

8・8

Chapter 8 Monitor (Multipoints Monitor)

8-2 Multipoints Monitor

[1] Function

You can monitor manual data in the data memory or system memory (maximum 128 items).

(Display example)

Data items are renewed by communicating with the PC, and following the assigned monitor type at

each row.

Content

●Input method

・You can input the address to be monitored directly in the address cell.

・Right-click the address to be monitored in each of the

Program:Ladder/System/Data/Symbol windows of JW-100SP. In the short

cut menu, select [Send]-[Multipoints Monitor].

・Select the cell including the address to be monitored in the

Program:Ladder window of JW-100SP, and select [Tool]-[Multipoints

Monitor] in the menu bar.

Data items are renewed by communicating with the PC, and following the

assigned monitor type at each line.You can modify the current value of the

●Modify data of register

If you double-click the cell monitoring the register or select the cell and

push the [Enter] key, "data item will change to the input mode. If you input

the [Enter] key after inputting an optional numerical value at the input

mode, you can change data. During the monitoring, you can also change

data of the PC at the same time .

●Set/reset of the relay

if you click on the right side of the mouse on the line monitoring the relay,

the short cut menu that carries set/reset as their items will be displayed. If

you select set/reset by this menu, you can set/reset the relay.

Item

Address

Data

⇒ Refer to the Sample Operation 2.

⇒ Refer to the Sample Operation 1.

(To next page)