Instruction manual

7・10
Chapter 7 Setup Each Data (Setup Parameter)
■■
■■
■ Setup/Display of Property Sheet
Setup/display the parameter in property sheet type.
If you click [Property sheet] of the switch number (special I/O /option) which is to be assigned, the
property sheet that was setup at the [Model setup list] will be displayed.
Click [Property Sheet]
(PC model : JW30H display)
●●
●●
● Property Sheet
(Display PC model : JW30H, module name : JW-21HC (mode 0, 3, 5))
・Depends on each module, the setup content of the property sheet varies.
・ The parameter that is setup by the property sheet is the parameter that will be stored in the main PC.
There is an module that stores the parameter inside the module. In this case, setup at the " Option
parameter tool " window. ⇒ Refer to the next page.
Notes