Instruction manual

7・8
Chapter 7 Setup Each Data (Setup Parameter)
7-4 Setup Parameter
■■
■■
■ Summary Display/Operation of Parameter
In case of the PC model series JW20/JW30H, the parameter of the special I/O module/option module is
setup at the parameter window. (In other model series, the parameter window is not used.)
At the parameter window, the address and data will be displayed.
Address chart
Data chart
・To edit the data, locate the area with the scroll bar, click the data cell, push the [Enter] key, and
input the numerical values.
・During the monitoring (PC on-line), the memory volume of the PC will be displayed.
(1) Operation in the parameter display area
・You can select one cell with single click.
・You can select several cells with drag.
・You can cut/copy/paste the selected area by the [Edit] menu , or by the shortcut menu which is
displayed by clicking the right of the mouse.
(2) Select operation of display
You can operate the following using the [Display] menu or the toolbar for editing data.
・Select data display of the data memory from binary notation/octal notation/decimal notation/
decimal notation (with +-)/ hexadecimal notation, or ASCII.
・Select the data length of the parameter from byte/word/double word. This selection is all valid in
the display area of the parameter.
(PC model : JW-33CUH1 display)