Instruction manual

7・3
Chapter 7 Setup Each Data (Setup System Memory)
■■
■■
■ Manual I/O Registration (JW50/70/100,JW50H/70H/100H)
In case of JW50/70/100 and JW50H/70H/100H, you can setup the kind/points of the module that is to be
put on each rack/slot when using the JW input/output module.
You can do the setup at the displaying [Manual I/O Registration] dialog box after clicking the [Manual I/O
Registration] of the tree bar.
(PC model：JW50/70/100,
JW50H/70H/100H display)
Click [Manual I/O Registration]
●●
●●
● [Manual I/O Registration] dialog box
Item/Button of Setup /Operation
Rack Tab
Slot No.
Select the rack number (0 to 7)
Select the slot number.
Select the kinds of module from "input, output, special I/O (input, output,
input /output), dummy, no I/O."
Select the points in 16-point module.
Setup top address of the register for changing data with the special I/O module.
・The setup is valid when selecting the "special I/O" by the type of module.
The content of the setup unit will be displayed in the summary chart.
Setup the top address of rack
・The setup is valid when the rack number is between 1 and 7.
The top address of the setup rack will be displayed in the summary chart.
If you click module establishing button/top address establishing button,
setup/modified "slot number, kind of module, points, I/O address" will be
displayed in the selected rack.
Summary Chart
Front address establishing button
Top address of Rack
Module establishing button
Top address of Special I/O
Data Register
Points
Type of Module
Content
Open the [Confirmation (Manual I/O Registration)] dialog box to confirm
the settings. ⇒ Refer to the next page.
OK button
Rack tab
Module establishing button
Front address establishing button
Summary chart
OK button