Instruction manual

6・43
Chapter 6 Program Edit (Mnemonic Programming)
・If you click the button or the [F1] key after inputting TMR /CNT instructions, the display
will change to the following order.
TMR → DTMR (BCD) → DTMR (BIN) → UTMR (BCD) → UTMR (BIN)
CNT → DCNT (BCD) → DCNT (BIN) → UCNT (BCD) → UCNT (BIN)
・If you input an instruction, the spot where numerical values such as relay or register number,
timer /counter number and application instruction number will be waiting for the input.
3. Input relay or register number, timer・counter number, or application instruction number, and
then press the [Enter] key.
(Example of inputting address)
・There are no differences between upper and lower cases of [F], [C], [X], [W], [D], [B], [E].
・Select the cell in which the register is displayed, and if you input the [F1] key, the register
area will change in the following order.
]0000 → b0000 → 09000 → 19000 →
…
→ 99000 → E0000
■■
■■
■ Edit Mnemonic
・All mnemonic editing will be operated in program address module. You can select several
program addresses by the dragging operation.
・You can insert the NOP instruction by selecting the [Insert Row] command of the [Edit] menu, or
by selecting the [Insert] key.
・You can delete the instruction by selecting the [Delete Row] command of the [Edit] menu, or by
selecting the [Delete] key, However, you can not delete from the 2 nd to the fourth words of the
2 to 3-word instructions.
・You can copy or move the instruction by selecting the [Cut], [Copy], [Paste] commands of the
[Edit] menu.
dniK elpmaxE tupnI
sserddAyaleR10000]retnE[]1[
remiT ・ rebmuNretnuoC1000]retnE[]1[
remiT ・ puteSretnuoC
eulaV
1000]retnE[]1[
noitcurtsnInoitacilppA
rebmuN
000-F]retnE[]0[ro]retnE[]0[]F[
w210cF
]retnE[]W[]2[]1[]C[]F[
]retnE[]W[]2[]1[]C[ro
sserddAretsigeR
1000]]retnE[]1[]][
1000b]retnE[]1[]B[
10090]retnE[]1[]9[]0[
1000E]retnE[]1[]E[
00099@]retnE[]0[]9[]9[]@[
noitcurtsnInoitacilppA
rebmuNtnatsnoC
100]retnE[]1[