Instruction manual

6・36
Chapter 6 Program Edit (Ladder Programming)
【【
【【
【Display Position
】】
】】
】
Assign the display position of the coil (OUT instruction)
□ Align display
The coil display position is set according to the screen size.
When the setup of the next clause【Align position 】is "Align left," the 4 th cell from the right of
the screen become the display position of the coil. And when the setup is "Align right," the first
cell from the right of the screen will become the display position of the coil.
If the number of contacts of the horizontal direction exceed the screen size, the display position
will be set according to the number of the contacts. (The display position of coil will be set
outside the screen)
□ Specify Position
Assign the display position of the coil by the row number (0 to 61).
If the number of contacts of the horizontal direction exceed the assigned number, the display
position will be set according to the number of the contacts.
【【
【【
【Align Position
】】
】】
】
Assign the display position of TMR /CNT instruction and application instruction.
□ Align left
The display position of TMR /CNT instruction number and application instruction number will
be the display position of coil (OUT instruction).
□ Align right
The display position of TMR /CNT instruction number and application instruction number will
be the 4 th number from the left of the display position of coil (OUT instruction).
Example 1) Display position : arrange to the screen size Arrange position : Arrange in front
Example 2) Display position : assign position (row number 5) Arrange position : Arrange in back