Instruction manual

6・35
Chapter 6 Program Edit (Ladder Programming)
■■
■■
■ Arrange Ladder Diagram
You can adjust the display position of the output instruction (OUT instruction, /application
instruction, etc...) which was created at the [Program : Ladder] window, or you can execute the
automatic connection of the disconnected circuit or optimization of the ladder.
●●
●●
● Operation order
1. Display the ladder circuit at the [Program : Ladder] window.
2. Click [Display]-[Arrange Ladder Diagram] of the menu bar.
⇒ [Arrange Ladder Diagram] dialog box will be displayed.
3. If you click the [Exec.] button after checking the item to execute by the mouse, the ladder will
be arranged.
(1) Connection of the disconnected circuit
Connect the disconnected circuit. Only the horizontal line will be connected, however, and the
vertical line will not be connected.
Connection
(2) Adjustment of the display position
Adjust the display position of OUT instruction, TMR /CNT instruction, and application instruction.
You can either setup the display position by the [Open] button in the [Arrange Ladder Diagram]
dialog box, or by the [Setup Display] dialog box which can be displayed by clicking [Setup]-[Setup
Display] of the menu bar.