Instruction manual

6・34
Chapter 6 Program Edit (Ladder Programming)
2. Assign the reading position.
□ Insert to Cursor Position.
Read out to the row that contains the cell cursor of the [Program : Ladder] window.
□ Insert to Assigned Row.
Read out to the assigned row of the [Program : Ladder] window.
3. When there is a ladder circuit on the assigned line of the [Program : Ladder] window, select
either "over write" on the ladder circuit, or "insert" in front of the ladder circuit.
4. Setup the number of times of the ladder circuit being read continuously on the "repeat time."
In case you setup more than two times, read out by increasing /decreasing the relay
address or the register address , according to the number of increased/ decreased value.
If the number of repeat is one time, the increase /decrease value will not be affected.
5. If you click [OK] button, the reading of the ladder circuit to the [Program : Ladder] window will
start.
Example of the number of repeat being three times.
First reading
Second reading
Third reading