Instruction manual

6・29
Chapter 6 Program Edit (Ladder Programming)
(1) Edit ladder circuit
At the [Register Library] window, you can edit the ladder circuit in the same way as the [Program :
Ladder] window, but there are following exceptions.
●●
●●
● Clear whole screen
If you click [Insert]-[All Clear] of the menu bar, you can erase the whole ladder circuits of the
[Register Library] window.
(2) Setup increase /decrease value
You can read continuously (assigned times) the ladder circuit that was registered in the library, in
the [Program : Ladder] window. In this case, you can only read the assigned increase /
decrease value by increasing /decreasing the relay address or the register address.
(Example)
]reddaL:margorP[
wodniw
wodniw]yrarbiLretsigeR[ wodniw]yrarbiLdaeR[
tnemmoC/lobmyStupnIelbissoP
elbissopmI
)tupnisserddaylno(
elbissopmI
)tupnisserddaylno(
tnemmoC/lobmySyalpsiDelbissoP
elbissopmI
)yalpsidsserddaylno(
elbissopmI
)yalpsidsserddaylno(
noitcurtsnInoitacilppAtupnI
raBeerTehtyb
elbissoPelbissopmIelbissopmI
ylsuounitnoCdniFelbissoPelbissopmIelbissopmI
lioCdniFelbissoPelbissopmIelbissopmI
mooZelbissoPelbissopmIelbissopmI
kcehCmargorPelbissoPelbissopmIelbissopmI
hctaBniataDtrevnoCelbissoPelbissopmIelbissopmI
esaerceD/esaercnIputeS
eulaV
elbissopmIelbissoPelbissoP
ledoMCPtceleSelbissoP
elbissopmI
ehtfoledomehtsemoceb(
[]reddaLm:argorP)wodniw
elbissoP
-WJybdetratsledomehT(
ehtfoenoehtsemocebPS001
)wodniw]reddaL:margorP[
otegnahC
yalpsiDcinomenM/cinomenM
elbissoPelbissopmIelbissopmI
Repeat 5 times