Instruction manual

6・17
Chapter 6 Program Edit (Ladder Programming)
【【
【【
【Widen /Narrow Application Instruction's Frame
】】
】】
】
Setup the button movement of the toolbar for editing ladder by the application instruction (F-
60,F-61,F-62, etc.) waiting for the several inputs or by CNT instruction.
You can not narrow the instruction frame in the dialog input mode.
□ Process with Row Data
a) In case of direct input mode
If you click the button, the mouse cursor changes to the enlarge/contract cursor. If you
drag the enlarge/contract cursor to the instruction frame area of the line where you want to
widen, the instruction will be widened /narrowed in vertical direction. At the same time, the
line of input contact will move.
b) In case of dialog input mode
If you click the button when there is the cell cursor in the instruction frame of the line
where you want to widen, the instruction will be widened in vertical direction. At the same
time, the line of input contact will move.
□ Process Application Instruction Only
a) In case of direct input mode
If you click the button, the mouse cursor changes to the enlarge/contract cursor. If you
drag the enlarge/contract cursor to the instruction frame area of the line where you want to
widen, the instruction will be widened /narrowed in vertical direction. The line of input contact
will not move.
b) In case of dialog input mode
If you click the A button when there is the cell cursor in the instruction frame of the line where
you want to enlarge, the instruction will be enlarged in vertical direction. The line of input
contact will not move.
・If you double click the mouse on the cell displaying the application instruction number, the
display will change to the following in order. (The change differs according to the PC model.)
F-XXX→F-XXXw→F-XXXd→FcXXX→FxXXX→FcXXXw→FxXXXw
The application instruction number does not change, however.
・In the direct input mode, if you double click the mouse on the cell which is not displaying
anything , the display will change to the following in order.
A contact→B contact→horizontal line→coil
・In the dialog input mode, you can not double click the mouse on the cell which is not
displaying anything.
・If you double the mouse on the vertical line input position, a vertical line will be input.