Instruction manual

6・16
Chapter 6 Program Edit (Ladder Programming)
【【
【【
【Double Click
】】
】】
】
□ Becomes Address Input
If you double click the mouse on the cell which accepts the address input, the instruction input
mode changes to the address input mode.
□ Changes Instruction at Cell
・If you double click the mouse on the cell displaying the basic instruction (A contact, B
contact,horizontal line, coil), the display will change to the following in order.
A contact→B contact→horizontal line→coil
The relay number does not change, however.
・ If you double click the mouse on the cell displaying the number of timer, counter instruction,
the display will change to the following in order. (The change differs according to the PC
model.)
TMR→DTMR (BCD)→DTMR (BIN) →UTMR (BCD) →UTMR (BIN)
CNT→DCNT (BCD)→DCNT (BIN) →UCNT (BCD) →UCNT (BIN)
The timer number and the counter number do not change, however.
【【
【【
【Serial Input of Address
】】
】】
】
□ Do
If you input the address during the address input mode and press the [Enter] key, you can
input the address of the cell which is found just on the right side. (In case there is no cell on the
right side for the address input, move to the valid cell for the address input.)
In this case, you can change the instruction input mode by moving the cursor to the different
cell, or by selecting the [ESC] key.
□ Undo
If you input the address during the address input mode and press the [Enter] key, you can
change to the instruction input mode.
■■
■■
■ Setup Input Type
Click [Setup]-[Setup Input Type] of the menu bar, and display the [Setup Input Type] dialog box.
【【
【【
【Input Mode
】】
】】
】
Select either dialog input /direct input
□ Inputs at Display Directry
It becomes the direct input mode.
□ Inputs Using Dialog
It becomes the dialog input mode.