Instruction manual

6・14
Chapter 6 Program Edit (Ladder Programming)
●●
●●
● In case of inputting the address
・When the display type is Normal(address)/Comment(8c, 4l)/Comment(16c, 2l)/
Full(Address/Symbol/Comment). (Refer to page 6-2)
In case the display type is Comment(8c, 4l)/Comment(16c, 2l)/Full(Address/Symbol/
Comment), the input dialog box is shown to input the address. You can also input the symbol
and the comment in that dialog box.
(2) Input Address
・When inputting the instruction in the dialog input mode, you normally input the relay address,
register address, application instruction number, etc. at the dialog box, but in case you want to
modify the once setup address, change the instruction input mode to the address input mode.
(Instruction input mode) (Address input mode)
・ To change from the instruction input mode to the address input mode, select the instruction cell
by the arrow-shaped cursor, and use "double click" or the [Enter] key. "Double click" by the
mouse is only valid when the "Becomes address input" at the setup of [Double Click] of the
[Setup Input Type] dialog box is selected.
(Example of address input)
・ There are no differences between upper and lower cases of [F], [C], [X], [W], [D], [B], [E].
Depends on the kind of application instruction, there is a case when the dialog box is
displayed instead of inputting the address directly. (the 3rd word of JW30H F-85, etc.)
・ Select the cell in which the register is displayed, and if you input the [F1] key, the register
area will change in the following order.
]0000 → b0000 → 09000 → 19000 → ････ → 99000→E0000
dniK elpmaxE tupnI
sserddAyaleR10000]retnE[]1[
remiT ・ rebmuNretnuoC1000]retnE[]1[
remiT ・ puteSretnuoC
eulaV
1000]retnE[]1[
noitcurtsnInoitacilppA
rebmuN
000-F]retnE[]0[ro]retnE[]0[]F[
w210cF
]retnE[]W[]2[]1[]C[]F[
]retnE[]W[]2[]1[]C[ro
sserddAretsigeR
1000]]retnE[]1[]][
1000b]retnE[]1[]B[
10090]retnE[]1[]9[]0[
1000E]retnE[]1[]E[
00099@]retnE[]0[]9[]9[]@[
noitcurtsnInoitacilppA
rebmuNtnatsnoC
100]retnE[]1[
・Input the address in the numerical value key. You can omit "0’s" of the high digit number.
Comment(8c, 4l)/Comment(16c, 2l) Full(Address/Symbol/Comment)