Instruction manual

6・13
Chapter 6 Program Edit (Ladder Programming)
(1)-6 Input order of F-43 (bit reverse), F-44 (ON differential), F-45 (OFF differential)
instruction
1. Move the cursor to the position where you input the instruction.
2. if you select each instruction from the toolbar for editing ladder, the [Instruction] menu and the
assigned key, the instruction will be input.
(1)-7 Input order of F-20 (MD) instruction
1. Move the cell cursor to the position where you input the instruction.
2. If you click F-20 (MD) instruction of the [Instruction] menu or press the function key ([Shift]+
[F8]), [Input F-20 (Maintenance Display)] dialog box will be displayed.
3. Setup the number of input lines, MD number and MD data.
4. Click [OK] button to input the instruction.
●●
●●
● In case of inputting the symbol
・Input the symbol within 16 characters.
・There are two methods of creating a program by the symbol input.
① Create a program using the symbol that has already been registered at the [Symbol]
window.
② After creating a program by using the un-registered symbol, assign the address at
the [Assign Symbol] window.
6. For the instruction that has been setup with the constant, input the constant
by the numerical value key.
7. If you click [OK] button, the instruction will be input.