Instruction manual

6・12

Chapter 6 Program Edit (Ladder Programming)

(1)-5 Input order of application instruction 2 (In case of selecting the instruction by the tree

bar.)

1. Move the cursor to the position where you input the instruction.

2. At the tree bar, the application instruction is classified according to the function. If you click "+"

of the tree, or double click the instruction, the instruction at the lower layer will be displayed.

3. Click "+" until the inputting instruction will be displayed at the tree bar.

4. If you click the inputting instruction, the dialog box of each instruction will be displayed, and

select the input type (Address /Symbol) by the mouse for the instruction that has the "setup

it with the mouse.

7．For the instruction that has been setup with the constant, input the constant by the numerical

value key.

8．If you click [OK] button, the instruction will be input.

5. For the instruction that has the "setup register /relay," input the address or symbol.

●●

●

In case of inputting the address

・In case of "setup register," press button, and display the register area, and finally

select the area that contains the register to setup.

・Input the address by the numerical value key. You can omit "0’s" of the high digit

number.