Instruction manual

6・11
Chapter 6 Program Edit (Ladder Programming)
(1)- 4 Input order of application instruction 1 (In case of selecting the instruction at the
dialog)
1. Move the cell cursor to the position where you input the instruction.
2. Select instruction (FUN) from the toolbar for editing ladder, the [Instruction] menu and the
assigned key.
3. When the [Select Application Instruction] dialog box is displayed, select the instruction to input
in the "General classification", "Detail classification" and "Instruction" by double clicking the
mouse in order.
([Select Application Instruction] dialog box)
6. For the instruction that has the "setup register /relay," input the address or symbol.
●●
●●
● In case of inputting the address
・In case of "setup register," press button, and display the register area, and finally
select the area that contains the register to setup.
・Input the address by the numerical value key. You can omit "0’s" of the high digit
number.
●●
●●
● In case of inputting the symbol
・Input the symbol within 16 characters.
・There are two methods of creating a program by the symbol input.
① Create a program using the symbol that has already been registered at the [Symbol]
window.
② After creating a program by using the un-registered symbol, assign the address at the
[Assign Symbol] window.
4. If the instruction is displayed at the part of the "Inputs instruction," click [OK] button.
5. The dialog box of each instruction will be displayed, and select the input type (Address /
Symbol) by the mouse for the instruction that has the "setup register / relay." Also, if you want
to assign the address to the register indirectly, you can check it with the mouse.