Instruction manual

6・10
Chapter 6 Program Edit (Ladder Programming)
(1)- 2 Input order of basic instruction (horizontal line, vertical line)
1. Move the cell cursor to the position where you input the instruction (horizontal line, vertical
line).
2. If you select instruction (horizontal line vertical line) from the toolbar for editing ladder, the
[Instruction] menu and the assigned key, horizontal line /vertical line will be input.
(1) - 3 Input order of basic instruction (TMR, CNT)
1. Move the cell cursor to the position where you input the instruction.
2. Select the instruction (TMR, CNT) from the toolbar for editing ladder, the [Instruction] menu
and the assigned key.
3. When the dialog box is displayed, select by mouse the TMR type, the numerical value type and
the input type (TMR No./Symbol) for TMR instruction, and select by mouse the CNT type, the
numerical value type and the input type (CNT No./Symbol) for CNT instruction.
[TMR Instruction] dialog box
[CNT Instruction] dialog box
4. Input the address (TMR No./CNT No.) or symbol.
●●
●●
● In case of inputting the address
・Input the address by the numerical value key. You can omit "0’s" of the high digit
number.
●●
●●
● In case of inputting the symbol
・Input the symbol within 16 characters.
・There are two methods of creating a program by the symbol input.
① Create a program using the symbol that has already been registered at the [Symbol]
window.
② After creating a program by using the un-registered symbol, assign the address at
the [Assign Symbol] window .
5. Input the setup value by the numerical value key.
6. If you click [OK] button, the instruction will be input.