Instruction manual
6・9
Chapter 6 Program Edit (Ladder Programming)
[2] Dialog Input Mode
If an instruction is selected, the dialog input mode display the dialog box where the relay address
and the register address are input.
In this mode, you can change between address /symbol input, change between application
instruction indirect /direct register, and the setup of the register area setup at the dialog box,
according to the each instruction.
(1) Input Instruction
・There are four types of instruction input methods.
① Click the button of the toolbar for editing ladder. (basic instruction, application instruction)
② Select the [Instruction] menu command. (basic instruction, application instruction)
③ Push the key assigned in the [Key Assignment] (basic instruction, application instruction)
④ Select the instruction from the tree bar. (application instruction)
(1)
--
--
-1 Input order of the basic instruction (A contact, B contact, OUT)
1. Move the cell cursor to the position where you input the instruction.
2. Select the instruction (A contact, B contact, OUT) from the toolbar for editing ladder,
[Instruction] menu, and the assigned key.
3. Select the input type (relay address /symbol input) by the mouse when the dialog box is
displayed.
[A contact] dialog box [B contact] dialog box
[OUT] dialog box
4. Input address or symbol
●●
●●
● In case of inputting the address
・ Input the relay address by the numerical value key. You can omit“0’s”of the high digit
number.
・When inputting TMR /CNT contact, press button. In case of TMR contact, click
[T0000], and in case of CNT contact, click [C0000], and finally input the address.
●●
●●
● In case of inputting the symbol
・Input the symbol within 16 characters.
・There are two methods of creating a program by the symbol input.
① Create a program using the symbol that has already been registered at the [Symbol]
window.
② After creating a program by using the un-registered symbol, assign the address at the
[Assign Symbol] window .
5. If you click [OK] button, the instruction will be input.