Instruction manual

6・7
Chapter 6 Program Edit (Ladder Programming)
(2) Input Address
・When inputting the instruction by the direct input mode, the relay address, register address,
application instruction number, etc. will be setup at the initial value so that you need to modify
them with the correct value.
・To change from the instruction input mode to the address input mode, select the instruction cell
by the arrow-shaped cursor, and use "double click" or the [Enter] key. "Double click" by the
mouse is only valid when the "Becomes address input" at the setup of [Double Click] of the
[Setup Input Type] dialog box is selected.
(Instruction input mode) (Address input mode)
●●
●●
● In case of inputting the address
・When the display type is Normal(address)/Comment(8c, 4l)/Comment(16c, 2l)/
Full(Address/Symbol/Comment). (Refer to page 6-2)
In case the display type is Comment(8c, 4l)/Comment(16c, 2l)/Full(Address/Symbol/
Comment), the input dialog box is shown to input the address. You can also input the symbol
and the comment in that dialog box.
・Input the address in the numerical value key. You can omit "0’s" of the high digit number.
・There are no differences between upper and lower cases of [F], [C], [X], [W], [D], [B], [E].
Depends on the kind of application instruction, there is a case when the dialog box is
displayed instead of inputting the address directly. (the 3rd word of JW30H F-85, etc.)
・Select the cell in which the register is displayed, and if you input the [F1] key, the register area
will change in the following order.
]0000 → b0000 → 09000 → 19000 → ････ → 99000→E0000
dniK elpmaxE tupnI
sserddAyaleR10000]retnE[]1[
remiT ・ rebmuNretnuoC1000]retnE[]1[
remiT ・ puteSretnuoC
eulaV
1000]retnE[]1[
noitcurtsnInoitacilppA
rebmuN
000-F]retnE[]0[ro]retnE[]0[]F[
w210cF
]retnE[]W[]2[]1[]C[]F[
]retnE[]W[]2[]1[]C[ro
sserddAretsigeR
1000]]retnE[]1[]][
1000b]retnE[]1[]B[
10090]retnE[]1[]9[]0[
1000E]retnE[]1[]E[
00099@]retnE[]0[]9[]9[]@[
noitcurtsnInoitacilppA
rebmuNtnatsnoC
100]retnE[]1[
(Example of address input)
Comment(8c, 4l)/Comment(16c, 2l) Full(Address/Symbol/Comment)