Instruction manual

6・6
Chapter 6 Program Edit (Ladder Programming)
(1) -3 Input order by the Assigned key
1. When the mouse cursor is the arrow-shaped cursor, move the cell cursor to the position where
you input the instruction.If the mouse cursor is the instruction cursor, change the instruction
cursor to the arrow-shaped cursor by clicking the right side of the mouse or use the [ESC] key,
or button.
2. If you press the assigned key, the instruction will be input. However, the address, application
instruction number become the initial value (see the previous page). The display of the
symbols and
comments is the same with the item 2 of (1)-1 above.
(1) -4 Input order of the application instruction by the tree bar
1．At the tree bar, the application instruction is classified according to the function . If you click
"＋" of the tree, or double click the instruction, the instruction at the lower layer will be displayed.
2．Click "＋" until the inputting instruction will be displayed at the tree bar.
3．If you click the inputting instruction, and move the cursor to the ladder display area, the
instruction cursor ( ) will be displayed.
4．Move the instruction cursor to the position of the inputting instruction. Click to input the
instruction. However, the address and the constant number become the initial value (relay:
00000, register: ]0000, constant:0). The display of the symbols and comments is the same with
the item 2 of (1)-1 above.
Initial value
(1)-5 Input order of the F-20 (MD) instruction
1. When the mouse cursor is the arrow-shaped cursor, move the cell cursor to the position where
you input the instruction.If the mouse cursor is the instruction cursor, change the instruction
cursor to the arrow-shaped cursor by clicking the right side of the mouse or use the [ESC] key,
or button.
2. If you click F-20 (MD) instruction of the
[Instruction] menu or press the function
key ([Shift]+[F8]), [Input F-20 (Maint-
enance Display)] dialog box will be
displayed.
3. Here, you setup the number of input
lines, MD number and MD data, and
click [OK] button to input the instruction.