Instruction manual

6・5
Chapter 6 Program Edit (Ladder Programming)
(1)-2 Input order by the [Instruction] menu
1. When the mouse cursor is the arrow-shaped cursor, move the cell cursor to the position where
you input the instruction.
If the mouse cursor is the instruction cursor, change the instruction cursor to the arrow-
shaped cursor by clicking the right side of the mouse or use the [ESC] key, or button.
2. If you click the instruction of the [Instruction] menu, the instruction will be input. However,
the address, application instruction number become the initial value (described above).
The display of the symbols and comments is the same with the item 2 of (1)-1 above.
(1)-1 The input order by the toolbar button.
1. Select the instruction of the toolbar by the mouse cursor. In case the mouse cursor is the arrow
-shaped cursor, it changes to the instruction cursor (described above).
2. Move the instruction cursor to where you input the instruction, and click it to input the
instruction. However, the address, application instruction number become the initial value
(described above).
・When the display type is "Symbol Display"/"Full Display (Address/Symbol/Comment)," the
symbol will be displayed only if the address of initial value of the symbol has been "symbol
registered."
・When the display type is Comment(8c, 4l)/Comment(16c, 2l)/Full(Address/Symbol/
Comment), the comment will be displayed only if the address of initial value of comment
has been "comment registered."
3. Only if the instruction cursor is , , , , you can input the instruction
continuously by dragging it on the screen.
4. To change the instruction cursor to the arrow-shaped cursor, click the right side of the mouse or
use the [ESC] key, or button.
Input method of instruction and the initial value of instruction cursor at the time of the input
rablooT
nottuB
noitcurtsnI
uneM
ybdengissayeK
tluafed
noitcurtsnI
rosruC
eulaVlaitinI
tcatnocA]S[
tcatnocB]D[
latnoziroH
enil
]F[
enillacitreV]G[
TUO]X[
RMT]V[
TNC]C[
NUF]B[
34F]H[
44F]J[
54F]K[