Instruction manual

Chapter 5 Menu Operation (Setup)
5・53
(5) In case of Ethernet connection (①∼④ ⇒ corresponding to page 5-48)
① Click [Ethernet]
(You do not have to use the communication port of ②. Its setting is disabled.)
③ Click [Setup in Detail].
⇒ [Communication Setup] dialog box will be displayed.
Operation Item
Operation content
IP Address
Specify the IP address set in the contact unit.
Port No
Specify the port number set in the contact unit.
Protocol
Specify the protocol set in the contact unit.
Set the contact unit to TCP_Passive or UDP. You cannot set it to TCP_Active.
Note: If you are using JW-50CM, only UDP is available.
Bind Port Set up the port the personal computer is using.
If you do not specify, Windows automatically set it up.
④ Click [OK]
⇒ The setup is completed.