Instruction manual

5・48
Chapter 5 Menu Operation (Setup)
■■
■■
■ Setup Communication (Main/Program/System/Data/Symbol/Parameter)
[1] Function
Setup the PC which will be the object of communication, or setup the communication port of the
personal computer.
[2] Operation Content
If you click [Communication Setup] by the [Setup] menu, [Communication Setup] dialog box will be
displayed.
①
②
③
④
・① to ④ will be compatible to the following ① to ④.
(1) In case of connecting with the PC itself
① Click [PLC itself].
② Set up the communication port and timeout duration of the personal computer.
③ When the model is JW30H, click [Setup in Detail].
⇒ [COM Baud Rate Setup] dialog box will be displayed.
・ Select either standard communication baud rate (19.2kbps) or high speed (115.2kbps).
The possible combinations of the communication during the high speed are the PC that
control module is JW-31CUH1/32CUH1/32CUM1/33CUH1/33CUH2/33CUH3, and it is lim-
ited to the personal computer that is compatible to 115.2kbps. If the personal computer is not
compatible to 115.2kbps, select the high speed (115.2kbps). You will be then able to commu-
nicate by 19.2kbps.
④ Click [OK]
⇒ The setup will be completed.
Operation Method
Operate the PC by connecting the unit between the personal computer and
the PC with the communication adapter（JW-100SA）and connection cable.
・When the model is JW30H, you can setup the communication baud rate.
Connect the personal computer to the network module/ ME-NET module , and
operate the PC which is connected to the satellite net /ME-NET/SUMI-NET.
Connect the personal computer to the remote I/O slave station module
( JW-20RS), and operate the master PC that is connected to the satellite net.
Connect the personal computer to the network module through modem, and
operate the PC.
Operate the PC connected to Ethernet.
Communication object
PC itself
Network
Remote I/O
Modem
Ethernet