Instruction manual

5・42
Chapter 5 Menu Operation (Display)
■■
■■
■ Arrange Ladder Diagram (Program : Ladder)
(1) Function
You can optimize the following: the connection of the disconnected circuit of the created ladder
circuit, adjustment of the display position of the output instruction (OUT instruction, /application
instruction etc), re-arrangement of the MCS/JCS condition display,re-arrangement of the ladder
diagram’s layout.
・For more details of the display example etc., refer to the pages 6-35 to 37.
(2) Operation content
① Click [Display]-[Arrange Ladder Diagram]
by the menu bar of the program : ladder.
⇒ [Arrange Ladder Diagram] dialog box
will be displayed.
② Select item
Click the check box of the item to execute.
⇒ The check mark is displayed.
③ Setup screen
Click [Open] button when setting up the screen for adjustment of the display position.
⇒ [Setup Display Pattern] dialog box will be displayed.
The setup at the [Setup Display Pattern] dialog box is same as the setup at the [Setup]-[Setup
Display Pattern], so please refer to the page 5-57.
If you click [OK] at the [Setup Display Pattern] dialog box, or click [Cancel] button,
you will be back to the [Arrange Ladder Diagram] dialog box.
④ Click [Exec.]
⇒ Execute the item of the check mark.
Content
Re-connect the disconnected circuit. Only the horizontal line can be
connected, and you can not connect the vertical line.
Adjust the display position of the OUT instruction, TMR/CNT
instruction, application instruction.
You can setup the display position by selecting the [Open] button
inside the [Arrange Ladder Diagram] dialog box, or at the [Setup
Display Pattern] dialog box by clicking [Setup]-[Setup Display
Pattern] by the menu bar.
Check the valid area of the MCS(F-30), JCS(F-41)condition, and
display "M" (MCS), "J" (JCS) to the row number of the valid area.
Omit unnecessary horizontal lines of the ladder circuit, and gather
the ladder element to the left side.
Item
Connection of
Disconnected Circuit
Adjustment of Display
Position
Arrangement of MCS JCS
Condition’s Display
Re-arrangement of Ladder
Diagram’s Layout