Instruction manual

1・2
Chapter 1 Introduction
1-2 Compatible PC Model
The following JW series PC models are compatible to this software:
JW-1324K、JW-1424K、JW-1624K
JW-1342K、JW-1442K、JW-1642K
JW-21CU、JW-22CU
JW-31CUH、JW-32CUH、JW-33CUH
JW-31CUH1、JW-32CUH1、JW-32CUM1
JW-33CUH1、JW-33CUH2、JW-33CUH3
JW-50CU、JW-70CU、JW-100CU
JW-50CUH、JW-70CUH、JW-100CUH
Z-311J、Z-312J、Z-313J、Z-511J、Z-512J
JW-32CV1、JW-32CV2
JW10
ZW-160CU
ZW-501CU、ZW-501CU2、ZW-501CU3
W16/51
ZW-1K0CU、ZW-1K1CU
ZW-1K2CU、ZW-1K3CU
W100
JW20,JW20H
ZW-70CU、ZW-1HCU
W70H/100H
JW30H
JW50/70/100
JW50H/70H/100H
J-board
VME built-in controller
Control Module (CPU)P C
・You can connect your programmable controller to other optional modules than above.
・For the connection between the personal computer and the programmable controller, refer to
the next page.
・For the settings of each model, refer to page 5-5 and 5-46.
1-3 System Requirements
This software can be used by any personal computers that satisfy the following operating
environments:
Item
System Requirements
Personal computer
CPU
Operating system
Memory
Hard disk
Monitor
CD-ROM drive
RS-232C port
Mouse
Printer
IBM PC personal computer or NEC PC-9800 series
More than 90MHz of Pentium (More than 200MHz of Pentium
recommended)
Microsoft Windows 95/98/Me
Microsoft Windows NT4.0
More than 32M bytes (more than 64M bytes recommended)
30M bytes of the empty area
More than SVGA (800×600 dots of the resolution,
more than16 color)
One model
More than 1 port
Microsoft mouse or interchangeable pointing devise
(operations only by the keyboard are possible)
Printer that can be used under Windows 95/98/Me/NT
environment,when printing the ladder drawing, for example